Woot! Ty is here!! Welcome aboard!

I've been hosed so many times on handle materials... with ANY natural material I simply will not buy unless I can see it first hand. Buying off the ...

I agree with both Anthony, and Matt. I have to ask the question, what prompted you to want to do a 5000 layer billet? The amount of time steel w...

What tools and jigs do we use? I would say that one of the most important tools is a GOOD, CARBIDE file guide. These tools are certainly not ch...

So is the readout on the controls not accurate? Based on what I've found, that's the catch.... the percentage of accuracy can be based on just ...

There was a time when I would have recommended Paragon hands down, but over the last few years, their customer service has taken a severe nose dive. ...

The only logical way to incorporate that into a blade would be San-Mai. As has been said, it will not harden. With the nickel and magnesium content,...

Over the years I've learned that it's not about what I've done as a demonstrator, it's about the group I'm presenting to. Often times what I think i...

Yes. The "swirl" is very obvious when the forge is running. Probably the biggest down side the this particular forge is the "warm up" time..... It ...