The needle valve in the forced air burner basically replaces the orifice in the Venturi system. It reduces flow and increases back pressure behind the...

Andrew, I have built two forced air burner forges. The first one was a vertical forge with a 2 inch pipe for the burner at the bottom of a section of ...

A photo or two of your set up might help folks trouble shoot the problem.

[quote name='Thaddeus Stager' date='19 February 2021 - 03:59 AM' timestamp='1613732379' post='27551'] Excellent work Joshua!! Adam did ...

Thank you for the treatment suggestion Brion. I'll have to store that in my ever-fading memory bank for future reference. Hopefully, I can retain it&#...

Thank you Adam

Thanks Matt. This just shows that it is always a good idea to ask for others to take a look and weigh in on what they see. So many good ideas and sugg...

I finished this today. O-1 flat ground drop point 3.5". Stabilized box elder handle Guard and primary spacer is red bronze. Minor spacer and pin are n...

I finally put this together and domed the pins. Now to make the sheath. A question for those of you who work with ivory regularly. I have never put ...

Welcome Alma. Hope to see you post some pics soon. Stay warm & healthy.

Good to see you again Steve. Always a pleasure having you show up an absolutely slay me with a fine piece of craftsmanship. That one is seriously over...

Welcome Pierre. I see you are from my old stomping grounds. Woosta. Take the Pike outta town, as we used to say.

[quote name='Pedro Bassi' date='21 February 2021 - 11:41 AM' timestamp='1613932912' post='27571'] This 5160 was requested by the client. On...

Basically, what Matthew said with one added bit. I like forging the tip rather than cutting first and forging from the cut point. Forging the tip down...

It has taken a little while to get back to this. I had a small home remodel that took up most of my free time the last few weeks. Anyway, it was tim...